Sony EVID90 User Manual (EVI-D80/D90 User Manual) - Page 20

Pan/Tilt Mode Power On Pan/Tilt normal status Command Power Off1) IFC2) Initializing3) Zoom (Direct) Focus (Direct) Pan/tilt Absolute Relative movement Position Position according to the command4) execution execution Home execution Reset execution Memory Recall During Position displaying the detection error menu Transmit device Common Common VISCA RC VISCA VISCA VISCA RC VISCA RC VISCA RC Pan-tiltDrive Up/Down/Left/ VISCA No No No Yes Yes Yes Yes No No No No No No No No No Right/UpLeft/UpRight/ DownLeft/DownRight RC No No No Yes Yes Yes No No No No No No No No No No Yes 8) Yes 8) Pan-tiltDrive Stop VISCA No No No Yes Yes Yes Yes No No No No No No No No No Yes Pan-tiltDrive AbsolutePosition VISCA No No No Yes Yes No No Yes No No No No No No No Yes 5) No Pan-tiltDrive RelativePosition VISCA No No No Yes Yes No No No No No No No No No No Yes 5) Yes VISCA No No No Yes Yes No No No No Yes No No No No No No No Pan-tiltDrive Home RC No No No Yes Yes No No No No No Yes No No No No No No Pan-tiltDrive Reset VISCA No No No Yes Yes No No No No No No No No No No Yes 5) Yes RC No No No Yes Yes No No No No No No No No No No Yes 5) Yes Pan-tiltLimitSet LimitSet VISCA No No No Yes Yes Yes Yes No No No No No No No No Yes 5) No Pan-tiltLimitSet LimitClear VISCA No No No Yes Yes Yes Yes No No No No No No No No Yes 5) No Memory Set Common No No No No No No No No No No No No No No No No No Memory Reset Common No No No No No No No No No No No No No No No No No Memory Recall VISCA No No No No 6) No 7) No No No No No No No No Yes Yes No No RC No No No No 6) No 7) No No No No No No No No Yes Yes No No CAM_NR 9) VISCA No No No Yes Yes No 10) No 10) No 10) No 10) No 10) No 10) Yes Yes No No Yes 5) Yes 1) DC power is being supplied, but the camera has been turned off by a VISCA command. 2) The period from the time IF Clear is sent, until the Reply Packet is returned. 3) The period from the time DC power is turned on or the camera is turned on via a VISCA command, and the camera subsequently finishes the pan/tilt reset operation and stops at the Home position, until the video signal is output. 4) The pan/tilt operation works by Pan-tiltDrive Up/Down/Left/Right/UpLeft/UpRight/DownLeft/DownRight commands. 5) When the menu display is updating, operation is not possible. 6) Yes: while the camera operates in Tele/Wide zoom mode. 7) Yes: while the camera operates in Far/Near focus mode. 8) Yes: only for movements away from the direction where a position detection error has been recognized. 9) When CAM commands or other inquiry commands are received after the pan/tilt movement has been stopped, "Command not executable" may be returned for a maximum of 120 msec due to internal processing. In this case, please transmit the command again. 10) Yes: when pan/tilt moves at high speed. Basic Functions 20