Sony EVID90 User Manual (EVI-D80/D90 User Manual) - Page 43
D70 Mode, Overview, Switching the Mode
View all Sony EVID90 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
D70 Mode Overview The D70 mode allows you to control the EVI-D80N/ D80P/D90N/D90P using VISCA commands for the EVI-D70/P. Most of the VISCA commands for the EVI-D80N/D80P/D90N/D90P correspond to one for the EVI-D70/P. However, some of the VISCA commands for the EVI-D80N/D80P/D90N/D90P are different from those for the EVI-D70/P in definitions of parameters. When you send those commands to an EVI-D80N/ D80P/D90N/D90P whose D70 mode is set to ON, the camera translates the parameters for the EVI-D70/P to those for the EVI-D80N/D80P/D90N/D90P and executes the command. The following parameters are subject to translation. Zoom position Pan-tilt speed Pan-tilt position Notes Even if you set the D70 mode to ON, the EVID80N/D80P/D90N/D90P may not emulate the EVI-D70/P perfectly. This is caused by differences in hardware between the two models. The functions that are provided with the EVI-D70/ P but not with the EVI-D80N/D80P/D90N/D90P cannot be executed. Switching the Mode You can switch the D70 mode ON or OFF by switching the BOTTOM switch at the bottom of the EVI-D80N/ D80P/D90N/D90P. To change the D70 mode setting, move the BOTTOM switch to ON or OFF while the camera's power is off or the camera is in standby mode. Then, turn the power on by connecting the camera to an AC outlet or by using the VISCA commands or the Remote Commander. It takes about 7-16 seconds for the image to be displayed after Pan/Tilt initialization motion has stopped. Do not turn off DC power until the image has been displayed. The mode will not change if you change the switch setting of the BOTTOM switch after the power has been turned on. After you change the mode, previously saved position preset data will be lost. (Zoom, Pan/Tilt positions, etc. will be reset to their initial settings.) 43