Sony EVID90 User Manual (EVI-D80/D90 User Manual) - Page 6
Remote Commander, RS-232C/RS-422 select switch
View all Sony EVID90 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Locations of Controls IMAGE FLIP switch Flips the image upside down. Normally set this to OFF when you use the camera. When the camera is attached to the ceiling, set this to ON. Before you set the IMAGE FLIP switch, turn off the unit (or set to standby mode) and then, turn the power on by connecting the power adaptor, by VISCA control or the remote commander. When you switch this, the preset setting is returned to the initial setting. It takes about 7 to 14 seconds for the image displayed to respond to the setting change. IR SELECT switch VISCA RS-422 connector VIDEO(output) connector S VIDEO(output) connector VISCA IN connector VISCA OUT connector DC 12V connector Tripod screw hole BOTTOM switches Remote Commander 1 2 3 4 5 D70 mode switch Set to ON to use the VISCA command for EVI-D70/ D70P. IR OUT switch Set to ON to enable output of the receiver signals, which are transmitted from the infrared remote commander via the VISCA IN connector (page 25), or set it to OFF to disable the output. RS-232C/RS-422 select switch Set to ON to operate colour video camera using the VISCA command via the RS-422 interface. To change the mode, turn off the camera (not including standby mode) first, set the switch and then turn on the camera again. Mode switching is not possible while the camera is turned on. Baud rate select switch Set to ON for 38,400 bps or OFF for 9,600 bps. To change the mode, turn off the camera (not including standby mode) first, set the switch and then turn on the camera again. The mode cannot be switched while the camera is turned on. Switch 5 (Not used) Be sure to set this switch to OFF. Ceiling bracket mounting screw holes CAMERA SELECT buttons Press the button corresponding to the camera you want to operate with the Remote Commander. The camera number can be set using the IR SELECT switch on the rear of the camera. Note If two or more cameras are adjacent and have the same camera number, they are operated simultaneously with the same Remote Commander. When you install the cameras close to each other, set different camera numbers. For the camera number setting, see "Operating Multiple Cameras with the Remote Commander" described in the Operating Instructions supplied with the camera. FOCUS buttons Used for focus adjustment. Press the AUTO button to adjust the focus automatically. To adjust the focus manually, press the MANUAL button, and adjust it with the FAR and NEAR buttons. DATA SCREEN button Press this button to display the main menu. Press it again to turn off the menu. If you press the button when a lower-level menu is selected, the display goes back to a higher-level menu. Note Pan/tilt operations are disabled when the menu is displayed.