Sony HT-SF360 Operating Instructions - Page 25
When error codes appear, When you select WRN CHK, Confirming/saving the, measurement results
View all Sony HT-SF360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Confirming/saving the measurement results 1 Confirm the measurement result. When the measurement ends, a beep sounds and the measurement result appears on the display. Measurement Display Explanation result When the measurement process completes properly SAVE Proceed to step 2. When the measurement process fails ERROR XXXX See "When error codes appear" (page 25). 2 Press V/v repeatedly to select the item. Then, press . Item SAVE WRN CHK DIST LEVEL EXIT Explanation Saves the measurement results and exits the setting process. Displays warning concerning the measurement results. See "When you select "WRN CHK"" (page 25). Displays the measurement result for speaker distance. Displays the measurement result for speaker level. Exits the setting process without saving the measurement results. Note After "SAVE" is displayed for 50 seconds, the measurement result is saved automatically, without the need to save the procedure. 3 Save the measurement result. Select "SAVE" in step 2. The measurement results are saved. When error codes appear Try the remedies and perform the Auto Calibration again. Error code Cause and remedies ERROR 32 • The sound input from the optimizer microphone is out of the acceptable range. • The optimizer microphone or subwoofer may be damaged. Contact your Sony dealer or local authorized Sony service facility. ERROR F 33 The front speakers are not connected. Check that the front speakers are connected properly. ERROR SR 33 Either the surround left or surround right speaker is not connected. Check that the surround speakers are connected properly. ERROR SW 33 The subwoofer may be damaged. Contact your Sony dealer or local authorized Sony service facility. When you select "WRN CHK" If a warning on the measurement result is present, detailed information is displayed. Press or B to return to step 2 of "Confirming/saving the measurement results". Warning code Explanation WARN 40 The Auto Calibration has completed. However, the noise level is high. You may be able to perform the Auto Calibration properly if you try it again, even though the measurement cannot be performed in all environments. Try to perform the Auto Calibration in a quiet environment. continued 25US Getting Started