Sony KDS-R60XBR2 Operating Instructions - Page 71

Other Information Other Information Condition On a dual-feed cable system ("A" and "B" feed), the Guide collects data intermittently Explanation/Resolution ❏ The TV might be connected to the wrong feed. To test this, try changing the feed when you leave the TV in standby mode (i.e. when you turn the TV off using the POWER button on the remote control or front panel of the TV) to receive the updated Guide data. The Guide only updates data on the feed that originally collected the data. For example, if the Guide collected data on the "A" feed, then you must leave the TV on the "A" feed when you put it in standby mode. If you left the TV on the "B" feed in this example, the Guide would not be able to update any data. ❏ If, after trying both feeds, the Guide still does not have data, please contact Sony. Remote Control Condition Remote control does not operate Cannot change channels with the remote control Remote control does not operate non-Sony video equipment Explanation/Resolution ❏ The batteries could be weak. Replace the batteries. ❏ Check the orientation of the batteries. ❏ Press TV (FUNCTION) once, and the TV indicator lights up. You may have inadvertently pressed SAT/CABLE (FUNCTION), which changes the remote control to SAT or CABLE mode. ❏ Make sure this unit's power cord is connected securely to the wall outlet. ❏ Fluorescent lamps can interfere with remote control operation; try turning off the fluorescent lamps. ❏ Keep the remote control sensor area clear from obstacles. ❏ If the "WARNING: TV temperature is high." message appears, turn off the TV and wait until the TV's projection lamp cools down (approximately 5 minutes). If the remote control still does not work, make sure to dust the ventilation slots on the rear of the TV and the cooling fan to provide adequate ventilation around the TV. ❏ If you are using the TV to change channels, first press TV (FUNCTION) once, and the TV indicator lights up. ❏ If you are using another device to change channels, be sure you have not inadvertently switched your TV from the channel 3 or 4 setting. ❏ If you are using another device to change channels, be sure to press FUNCTION for that device. For example, if you are using your cable box to change channels, be sure to press SAT/CABLE (FUNCTION) once, and the SAT/CABLE indicator lights up. ❏ If you replaced the batteries to the remote recently, the code numbers for the video equipment may need to be reset. ❏ There may be more than one code for the equipment that you are attempting to operate. ❏ There is a possibility that some non-Sony equipment cannot be operated by your Sony TV remote. You may need to use the equipment's original remote control. 71