Sony KE-42TS2U Operating Instructions - Page 10
Connecting a VCR and Cable - power supply
View all Sony KE-42TS2U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Installing and Connecting the TV Connecting a VCR and Cable Use this hookup if: • You have cable TV that does not require a cable box. Disconnect all power sources before making any connections. 1 Connect the cable TV cable to the VCR's IN jack. 2 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack to the TV's VHF/UHF jack. 3 Using AUDIO and S VIDEO cables, connect the VCR's Audio and S Video OUT jacks to the TV's AUDIO and S VIDEO IN jacks. Rear of TV AUDIO-R (red) AUDIO-L (white) VIDEO (yellow) VIDEO IN 1 R AUDIO L VIDEO S VIDEO VIDEO IN 3 R AUDIO L DVI-HDTV AUDIO OUT R L R AUDIO L Y/G PB/B PR/R HD CONTROL S IN VD OUT VIDEO IN 2 VIDEO IN 4 SUB WOOFER S VIDEO VCR VHF/UHF AC IN VMC-810S/820S (not supplied) 75-ohm coaxial cable (supplied) Cable 10 (US) YC-15V/30V (not supplied) Tip If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable. When connecting both VIDEO OUT and S VIDEO OUT You can select which jack the TV receives the input signal from on the menu screen. You can set it for each video input (VIDEO IN 1 and VIDEO IN 2) separately. The TV is factory set to receive S VIDEO input signals. 1 Press TV/VIDEO repeatedly until the desired video input appears. 2 Press MENU. 3 Press V/v to select (Custom Setup), then press . 4 Press V/v to select "Auto YC," then press . 5 To watch the pictures input from the S VIDEO input jack: Press V/v to select "On," then press . To watch the picture input from the VIDEO input jack: Press V/v to select "Off," then press . 6 Press MENU to exit the menu screen.