Sony MHC-NX1 Operating Instructions (primary manual) - Page 21

1 Press CD, then place a CD. 2 Press PLAY MODE repeatedly until "PROGRAM" appears in the display. 3 Press one of the DISC 1~5 buttons to select a CD. To programme all the tracks on a CD at once, proceed to step 5. 4 Turn the jog dial until the desired track appears in the display. Disc number 3 PROGRAM Track number 5 Press ENTER. The track is programmed. The last programmed track and the total programmed track number appear, followed by the total playing time. Total playing time PROGRAM The last programmed track 6 To programme additional tracks, repeat steps 3 to 5. Skip step 3 to select tracks from the same disc. 7 Press ·. All the tracks play in the order you selected. To cancel Programme Play Press PLAY MODE repeatedly until "PROGRAM" or "SHUFFLE" disappears from the display. To Press Check the programme CHECK on the remote repeatedly. After the last track, "CHECK END" appears. Clear a track CLEAR on the remote in from the end stop mode. Clear a specific track CHECK on the remote repeatedly until the number of the track to be erased lights up, then press CLEAR. Add a track to 1 Select the disc tray with a the programme DISC 1~5 button. 2 Select the track by turning the jog dial. 3 Press ENTER. Clear the entire π once in stop mode or twice programme while playing. Tips • The programme you made remains in the CD player even after it has been played back. Press · to play the same programme again. • If "--.--" appears instead of the total playing time during programming, this means: - you have programmed a track number which exceeds 20 - the total playing time has exceeded 100 minutes. 21