Sony RM-VLZ620 Operating Instructions - Page 12

To check which Device Select button is set for a Sony device Press POWER in Step 3 above. The Device Select buttons set for Sony devices will flash in sequence. Device Select buttons set for nonSony devices will not flash. To set automatic power-on control again Perform the same procedure as when you clear the automatic power-on control. Notes  If you set the manufacturer's code of a non-Sony device on a Device Select button, you cannot set the automatic power-on control on the button. If you change to the code of a non-Sony device after setting automatic power-on control, the control will be cleared.  If you attempt automatic power-on control for a non-Sony device, the SET indicator will flash once and turn off (to indicate that you cannot set this control).  If you teach a signal or program a consecutive procedure to a Device Select button to which the automatic power-on control is set, the control will not work. To activate the control, clear the learned signal or programmed consecutive procedure from the Device Select button. Setting the Manufacturer's Code for Non-Sony Devices You can use the RM-VLZ620 for major brand A/V devices. To use with nonSony A/V devices, or Sony devices that are not preset at the factory (see table below for factory setting), you need to set the manufacturer's code for each device to any of the eight Device Select buttons. Device Select button Preset device Factory setting* TV Sony TV 02473 CBL (SAT) Cable set top box 51376 (non-Sony) DVR (PVR) Sony digital video 22676 recorder DVD Sony DVD player 11033 BD Sony Blu-ray Disc 11516 player VCR Sony VCR 60032 CD Sony CD player 70000 AMP Sony receiver 82586 * The five-digit code is the preset manufacturer's code. Notes  Only a TV or projector can be assigned to the TV Device Select button. You can assign any device to the other Device Select buttons. For button functions for each device, see "Table of Preset Functions" (page 36).  If no operations are performed for 10 seconds while setting, the setting will be canceled, and must be restarted.  Some devices that do not support infrared signals will not work with the RM-VLZ620. 12