Sony RM-VLZ620 Operating Instructions - Page 22

Note If the SET indicator flashes only once, it indicates that learning is incomplete. Repeat from Step 4 again. 7 Repeat Steps 4 to 6 to teach other new functions. 8 Press SET to finish teaching. The SET indicator turns off. To cancel the process Press SET anytime. Notes  If you teach a signal to a button, the learned function will remain even after you set a manufacturer's code.  You cannot teach a simultaneous button operation (for example  + ) to the two buttons on the RM-VLZ620 at a time. In this case, teach the signal to a single button while pressing two buttons on the original remote control at the same time. To teach an air-conditioner's functions If you adjust the setting of the airconditioner according to the season, reset the parameters of the air conditioner's remote control (temperature, air strength and direction, etc.), and teach the new remote signals to the RM-VLZ620. When the power button on the remote control for an airconditioner, etc., toggles between power-on and off with each press, the power-on/off operation may not be learned correctly. In this case, teach the power-on/off signals to two separate buttons on the RM-VLZ620. 1 Teach the power-on signal to a button (transmit the power-on signal by pressing the power button when the device is turned off ). 2 Teach the power-off signal to another button (transmit the power-off signal by pressing the power button when the device is turned on). The two learned buttons of the RMVLZ620 now control the power-on/ off signals of the device respectively. Note Devices such as air conditioners and heaters receiving an infrared signal can be dangerous if misoperated. Be sure to place the RMVLZ620 out of the reach of small children or pets, and lock the controls using the Hold function (page 31). Tips for teaching accurately  Do not move the remote control units during the learning procedure.  Use new batteries in both remote control units.  Avoid performing the learning procedure in places subject to direct sunlight, or strong fluorescent light. (Noise may interfere with the learning procedure.)  The remote control detector area may differ depending on each remote control unit. If the RMVLZ620 does not learn signals, try changing the positions of the two remote control units.  When you teach the signals of an interactive signal exchange system remote control unit (supplied with certain Sony's amplifiers) to the RM-VLZ620, the response signal of the main unit may interfere with the learning of the RMVLZ620. In such a case, move to a place where the signals will not reach the main unit (e.g., another room). 22