Sony STR-DA6400ES Using Network Features - Page 9
: Configuring the network settings of the receiver, To set the network settings, manually
UPC - 027242732100
View all Sony STR-DA6400ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Getting Started 2: Configuring the network settings of the receiver The network settings for the receiver must be set correctly to use the network functions of the receiver. You can make the required network settings for the receiver by following the instructions provided by an initial setup wizard. The procedure used to set up the IP address automatically (DHCP) is explained below. In this case, the router that is connected to the receiver or the Internet provider must support DHCP. AMP V/v/b, MENU 1 Press AMP. The receiver can be operated using the remote. 2 Press MENU. The menu is displayed on the TV screen. 3 Press V/v repeatedly to select " Settings," then press or b. 4 Press V/v repeatedly to select "Network," then press or b. 5 Press V/v repeatedly to select "Network Setup," then press . "Start Network function Setup Wizard" appears on the TV screen. 6 Press to select "Next." 7 Press to select "Connect Automatically (DHCP)." "Success! Your device is now connected to your network." appears on the TV screen when you have succeeded in making a connection. If the failure screen is displayed, perform the process referring to "Changing the network settings" (page 27), after you have completed this process. 8 Press to select "Finish." 9 Press to select "ON." The setting of the server function is turned to ON. Select "OFF," when you will not use the server function. 10Press to select "Finish." To set the network settings manually Refer to "Configuring network settings manually" (page 27). Note The wizard screen appears on the TV screen each time you use the network function, until the network function setup has been completed. 9GB