Sony STR-DA7ES Operating Instructions - Page 48
Advanced settings continued - component video switching
View all Sony STR-DA7ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Advanced settings (continued) x V.POWER (Video power management) • AUTO OFF Lets you turn off the power of the unnecessary video circuits automatically. You can enjoy high quality audio without the influence of video circuits. • ALWAYS ON Lets you keep the power of video circuits on. Depending on the monitor, noise may be produced or the picture may be distorted when the power of the video circuits is turned on. In this case, select "ALWAYS ON". x S.FIELD LINK (Sound field link) • ON Lets you apply the last selected sound field to a function whenever it is selected. For example, if you select STADIUM for CD/SACD function, change to a different function and return to CD/ SACD function, STADIUM is automatically applied again. • OFF Sound field link is not activated. x DECODE FORMAT (Digital audio input decoding mode) Lets you specify the input mode for the digital signal input to the DIGITAL IN jacks. • AUTO Automatically switches the input mode between DTS, Dolby Digital, PCM, or MPEG2. • PCM Decodes all the input signals as PCM signals. If a Dolby Digital, DTS, or MPEG (etc.) signal is input, no sound is output. When set to "AUTO", and the sound from the digital audio jacks (for CD, etc.) is interrupted when playback starts, set to "PCM". x AUTO FUNCTION (Control A1: Function link) • ON Lets you switch the function of this receiver to the Sony components connected via CONTROL A1 cords (page 61) automatically when the playback on the component is started. • OFF Function link is not activated. x 2 WAY REMOTE (2 way remote control system) • ON Lets you turn on the 2 way remote control system. Normally, select "ON". • OFF Lets you turn off the 2 way remote control system. When you use another receiver, etc. that is also compatible with the 2 way remote control system, together with this receiver, select the component for which you use the 2 way remote control system. Then set the 2 way remote control system for the component to "ON". For other components, set the 2 way remote control system to "OFF". x T.TONE (Test tone mode) Lets you select the test tone output mode (page 26). • NORMAL Lets you output the test tone from each speaker in sequence. • PHASE NOISE Lets you output the test tone from two adjacent speakers at a time in sequence. • PHASE AUDIO Lets you output the source sound instead of the test tone from two adjacent speakers at a time in sequence. x INSTALLER MODE (RS232C control) x 12V TRIG.MAIN (12 V trigger for the main room) x 12V TRIG.2ND (12 V trigger for the 2nd room) x 12V TRIG.3RD (12 V trigger for the 3rd room) (STR-DA7ES only) For details, see "Custom install mode" on page 57. 48GB