Sony STR-DE1015G Operating Instructions - Page 59
Additional, Information
View all Sony STR-DE1015G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Additional Information Severe hum or noise is heard. Check that the speakers and components are connected securely. •♦ Check that the connecting cords are away from a transformer or motor, and at least 10 feet (3 meters) away from a TV set or fluorescent light. ♦ Place your TV away from the audio components. mill. Make sure you connect a ground wire to the antenna ground terminal. The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol. No sound is heard from the center speaker. STR-DE1015G : Select a sound mode other than ACOUSTIC or KARAOKE (see page 37). STR-DE8156 / D760Z : Select a sound field using the center speaker: PRO LOGIC, MOVIE (except NIGHT THEATER and MONO MOVIE) (see page 38). STR-DE815G / D760Z : Select the appropriate center mode (see pages 24 and 25). ♦ Adjust the speaker volume appropriately (see page 23 for STR-DE1015G or pages 24 and 25 for STR-DE815G / D760Z). No sound or only a very low-level sound is heard from the rear speakers. Select a sound field other than ACOUSTIC. ♦ STR-DE815G / D760Z : Select the appropriate center mode (see pages 24 and 25). Adjust the speaker volume appropriately (see page 22 for STR-DE1015G or pages 24 and 25 for STR-DE815G / D760Z). Surround effect cannot be obtained. ♦ Turn on the sound field function. ♦ Set DIRECT PASS to OFF. Make sure you set the SPEAKERS selector correctly (see page 10). Tuner Radio stations cannot be tuned in. ••• Check that the antenna is connected securely. Adjust the antenna and connect an external antenna if necessary. The signal strength of the stations is too weak (when you tune in with Automatic Tuning). Use Direct Tuning (see page 29). ♦ Make sure you set the tuning interval correctly (when you tune in AM stations with Automatic Tuning) (see page 29 or 54 and 64). .4. No stations have been preset or the preset stations have been cleared (when you tune in with Preset Tuning). Preset the stations (see page 30). Display the frequency by pressing DISPLAY (when you tune with Automatic Tuning). Others IR codes of components cannot be registered. • When registering the IR code, be sure to check the following: • Point the remote at the IR sensor on the receiver from a distance of less than 2 inches (5 cm). • Hold down the button on the remote for about 2 or 3 seconds until the "RECEIVING" display switches to "RELEASE YOUR REMOTE". • Keep the remote pointed horizontally at the IR sensor until the code is registered. Recording cannot be made. ▪ Check that the components are connected correctly. ♦ Select the playback component with the remote or with the AUDIO FUNCTION or VIDEO FUNCTION controls on the front panel. A component cannot be selected ♦ Check the FUNCTION hookup setting of the component (see page 58 or 59). 62