Stihl 036 QS Instruction Manual - Page 47
Psruwdqw²
View all Stihl 036 QS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
A properly sharpened chain slices through wood effortlessly and requires very little feed pressure. Do not work with a dull or damaged chain as it will increase the physical effort required, produce unsatisfactory results and a higher rate of wear. for cracks in the links and damaged rivets replace any damaged or worn parts of the chain and match the new parts to the shape and size of the original parts. It is absolutely imperative to comply with the angles and dimensions specified below. If the - and in particular if the depth gauge is set too low - there is a risk of increased kickback of the chainsaw, with resulting . 3/8 The chain pitch (e.g. 3/8) is marked on the depth gauge side of each cutter. Other files have the wrong shape and cut. Select file diameter according to chain pitch - see table at the end of this chapter. You must observe certain angles when resharpening the chain cutters A B Filing angle Side plate angle Chain type Rapid-Micro (RM) Rapid-Super (RS) Picco-Micro (PM/PMN) Cutter shapes: Micro = Semi-chisel Super = Full chisel 689BA020 KN 689BA021 KN Angle (°) AB 30 85 30 60 30 85 . See "Technical Data" for the permitted chain pitches. Furthermore, the angles must be the same on all cutters. If angles are uneven: Chain will run roughly, not in a straight line, wear quickly and finally break.