Stihl FS 110 Product Instruction Manual - Page 23
Tighten tommy screw - throttle cable
View all Stihl FS 110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
N Remove the tommy screw - washer (6) remains on the tommy screw N Separate clamps - springs (4, 5) remain in the lower clamp! Fastening the handlebar A 8 7 English Attaching the control handle 250BA046 KN 002BA234 KN 1 N Position the handlebar (7) in the lower clamp (1) so that distance (A) is not more than 6 in. (15 cm) N Place the upper clamp on top and hold both clamps together N Insert the tommy screw with the washer on it through both clamps as far as it will go - hold all parts together and secure them N Position the entire secured assembly on the handlebar support (8) with the tommy screw facing the motor N Press the tommy screw into the handlebar support as far as it will go and then screw it in - do not tighten it down yet N Align the handlebar so that it is perpendicular to the shaft - check distance (A) N Tighten tommy screw N Unscrew the bolt (9) - the nut (10) remains in the control handle (11) N Push the control handle with the throttle trigger (12) facing toward the gearbox onto the end of the handlebar (7) until the holes (13) align N Screw in and tighten the bolt (9) Fastening the throttle cable Do not kink the throttle cable or run it in tight radiuses - the throttle trigger must move freely! FS 110, FS 110 R 21