Stihl FS 110 Product Instruction Manual - Page 26

English Adjusting the Throttle Cable Fitting the Carrying Ring Mounting the Deflector A properly adjusted throttle cable is the precondition for correct operation in the full throttle, starting throttle and idle positions. Adjust the throttle cable only after the unit is fully assembled - the control handle must be in the normal operating position. The carrying ring comes standard with the machine or is available as a special accessory. 1 Mounting the Deflector 1 3 N Use a suitable tool to push the slide to the end of the slot (see illustration). STOP 2 1 N Press down the throttle trigger lockout (1) and squeeze the throttle trigger (2) (full throttle) - this sets the throttle cable correctly. 249BA017 KN 002BA163 KN 1 2 For position of carrying ring see "Main Parts". N Place the clamp (1) against the drive tube with the tapped hole on the left (viewed from engine). N Squeeze the two ends of the clamp together and hold in that position. N Insert the M6x14 screw (2). N Line up the carrying ring. N Tighten down the screw firmly. 002BA142 KN 2 3 1 Deflector for mowing attachments 2 Deflector for mowing heads Deflectors (1) and (2) are both mounted to the gearbox in the same way. N Place the deflector on the gearbox flange. N Insert the screws (3) and tighten them down firmly. 002BA380 KN 24 FS 110, FS 110 R