Stihl FS 110 Product Instruction Manual - Page 29
STIHL TrimCut 31-2, STIHL FixCut 25
View all Stihl FS 110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
STIHL SuperCut 20-2, STIHL AutoCut 25-2, STIHL AutoCut C 25-2, STIHL TrimCut 31-2, STIHL FixCut 252, STIHL PolyCut 20-3 STIHL SuperCut 20-2, STIHL AutoCut 25-2, STIHL AutoCut C 25-2, STIHL TrimCut 31-2, STIHL FixCut 252, STIHL PolyCut 20-3 N Turn the mowing head clockwise Feed out mowing line English Replacing mowing line and/or cutting blade Proceed as described in the mowing head information sheet. Mounting metal cutting attachments 1 N Turn the mowing head counterclockwise until it is flush against the shaft (1) N Block the shaft N Tighten the mowing head Remove the tool used to block the shaft. Removing the mowing head 002BA081 KN STIHL SuperCut Line is fed out automatically if the mowing line is at least 2 1/2 in. (6 cm) long - the blade on the deflector shortens excessively long mowing line to optimum length. STIHL AutoCut N Hold the mowing head parallel above the surface of the lawn - tap it on the ground - approx. 1 1/4 in. (3 cm) of mowing line is fed out The blade on the deflector shortens excessively long mowing line to optimum length - thus repeated tapping in succession is to be avoided! Mowing line is only fed out if both mowing lines are still at least 1 in. (2.5 cm) long! For all other mowing lines Proceed as described in the mowing head information sheet. N Block the shaft Always switch off the engine to fed out mowing line by hand - otherwise there is a risk of injury! The skirt and lne limiting blade are not required on the deflector for grass cutting blades 230-4 (1), 230-8 (2) or the brush knife (3) - see "Mounting the Deflector". Fit the approriate limit stop for circular saw blades 200 (4, 5) - see "Mounting the deflector". Lay your brushcutter on its back with the cutting attachment mounting face pointing up: The cutting edges of (1) and FS 110, FS 110 R 27