TP-Link RE210 RE210(EU) V1 UG - Page 29
High Speed, 4.4.6 Wireless Statistics, Concurrent-Dual Band Range Extender
View all TP-Link RE210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
RE210 AC750 WiFi Range Extender User Guide Beacon Interval - Specifies a value between 40-1000 milliseconds. The beacons are the packets sent by the device to synchronize a wireless network. Beacon Interval value determines the time interval of the beacons. The default value is 100. RTS Threshold - Specifies the RTS (Request to Send) Threshold. If the packet is larger than the specified RTS Threshold size, the device will send RTS frames to a particular receiving station and negotiate the sending of a data frame. The default value is 2346. Fragmentation Threshold - This value is the maximum size determining whether packets will be fragmented. Setting the Fragmentation Threshold too low may result in poor network performance since excessive packets. 2346 is the default setting and is recommended. DTIM Interval - Determines the interval of the Delivery Traffic Indication Message (DTIM). You can specify the value between 1-255 Beacon Intervals. The default value is 1, which indicates the DTIM Interval is the same as Beacon Interval. Enable WMM - WMM function can guarantee the packets with high- priority messages being transmitted preferentially. It is strongly recommended enabled. Enable Short GI - This function is recommended for it will increase the data capacity by reducing the guard interval time. Enable AP Isolation - Isolates all connected wireless stations so that wireless stations cannot access each other through WLAN. 4.4.5 High Speed Selecting Wireless > High Speed allows you to configure the wireless mode for your device (show in Figure 4-15). Figure 4-15 High Speed Concurrent-Dual Band Range Extender - Extends both 2.4GHz and 5GHz bands for the router. High Speed Mode - Boost the WiFi speed but only one band could be extended. High Speed Mode 1 - Connect to the router on 2.4GHz only and connect to the WiFi clients on 5GHz only; High Speed Mode 2 - Connect to the router on 5GHz only and Extend to the WiFi clients on 2.4GHz only. 4.4.6 Wireless Statistics Selecting Wireless > Wireless Statistics will allow you to see the wireless transmission information in the following screen shown in Figure 4-16. 21