TP-Link T2600G-52TS TL-SG3452 T2600G-52TS V1 Installation Guide - Page 8

Gigabit L2 Managed Switch LED Status Indication On 1000Mbps Off A device is linked to the corresponding port and running at 1000Mbps. A 10/100Mbps device or no device is linked to the corresponding port. On A device is linked to the corresponding port and running properly. Link/Act Flashing Data is being transmitted or received. Off No device is linked to the corresponding port. Console (RJ-45) Port Designed to connect with the serial port of a computer or terminal for monitoring and configuring the switch. Console (USB) Port Designed to connect with the USB port of a computer for monitoring and configuring the switch. The switch has an RJ-45 console port and a micro-USB console port available. Console input is active on only one console port at a time. By default, the micro-USB connector takes precedence over the RJ-45 connector. 10/100/1000Mbps RJ45 Port Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each 10/100/1000Mbps RJ45 port has a corresponding 1000Mbps LED and Link/Act LED. SFP Port Designed to install the SFP module. T2600G-28TS features 4 individual SFP ports and supports 1000M SFP module connection only. The front panel of T2600G-52TS is shown as the following figure. Console(USB) Console Console (USB) Console (RJ-45) LEDs 10/100/1000Mbps RJ45 Port SFP Port Figure 1-2 Front Panel of T2600G-52TS LEDs LED PWR SYS Status On Off Flashing Flashing On/Off Indication The switch is powered on. The switch is powered off or power supply is abnormal. Power supply is abnormal. The switch works properly. The switch works improperly. 02 Introduction