TRENDnet TEW-841APBO Users Guide - Page 36

TRENDnet User's Guide Wireless Settings - Access Point / WDS Access Point Note: The following section configures wireless radios that are set to Access Point and WDS Access Point operation mode. WDS AP mode may not have all configurations available. For Access Point and WDS Access Point modes:  Enabled - Check the box to enable this wireless radio. Deselected box indicates radio is off.  SSID - The SSID of the radio.  2.4GHz - Check the box to apply this wireless profile to the 2.4GHz wireless radio.  5GHz - Check the box to apply this wireless profile to the 5GHz wireless radio.  Edit - To edit the advanced wireless settings, click Edit. Clicking Save in the pop-up window will return to the previous page. **if the pop-up window does not appear, please disable the browser's ad/pop-up blocker**  Security - Displays the security type assigned to this SSID.  Guest Network - Check the box to turn this profile into a guest network with its configurable subnet and DHCP server.  VLAN ID - This displays the VLAN ID or VID of this profile, if one has been assigned. TEW-841APBO Clicking Edit from above, Wireless Settings - Access Point opens up the advanced configuration options. Be sure to click Save prior to returning to the previous page. Wireless Setting - Access Point 2.4GHz/5GHz  Enable - Check the box next to the radio to apply this wireless profile to.  SSID - Enter the SSID you would like to assign to this wireless profile.  Hidden SSID - Select Enable to hide this SSID name from broadcasting.  Client Isolation - Select Enable to block communication between associated clients under the same WLAN.  VLAN Isolation - When this option is enabled with a specified VLAN ID in the SSID profile, all traffic associated with this SSID will be tagged with this VLAN ID upon entering the LAN Bridge.  L2 Isolation - Check the box to isolate on a layer-2 basis. Band Steering  Status - Select Enable to enable the band steering feature. Band steering facilitates effective spectrum usage, enabling 5GHz capable clients to associate with this AP's 5GHz radio, thus offloading bandwidth utilization in 2.4GHz band.  Band Steering - Click the dropdown to select the aggressiveness of the steering. Band steering f o Prefer 5GHz - Enter an RSSI signal strength value. When the connection drops below the value, the client will be moved over to the 2.4GHz band. (the more negative the number, the lower the signal strength. ex: -40dBm is significantly stronger than -80. o Force 5GHz - This option causes all 5GHz capable clients to connect to the 5GHz radio. o Band Balance - Similar to the Prefer 5GHz option, but additionally allows configuration of percentage of new clients on the 5GHz. © Copyright 2019 TRENDnet. All Rights Reserved. 33