Thermador CIT367XMS Instructions for Use - Page 11
Operation
![]() |
View all Thermador CIT367XMS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Cooking zones Cooking Zone Û Single cooking zone Always use cookware of a suitable size. Þ Middle single cooking zone Always use cookware of a suitable size. á Flexible cooking zone See section Use only cookware suitable for induction cooking; see the section ~ "Cooking with Induction" Residual heat indicator The cooktop has a residual heat indicator for each cooking zone. This indicates that a cooking zone is still hot. Do not touch a cooking zone while the residual heat indicator is lit up. The following indicators are shown depending on the amount of residual heat: ▯ Display •: High temperature ▯ Display œ: Low temperature If you remove the cookware from the cooking zone during cooking, the residual heat indicator and the selected heat setting will flash alternately. When the cooking zone is switched off, the residual heat indicator will light up. Even after the cooktop has been switched off, the residual heat indicator will stay lit for as long as the cooking zone is still warm. Operation Main power switch Use the main switch to turn on the electronic circuitry for the control panel. The cooktop is now ready to use. When you first switch on the appliance, you will be prompted to set up Home Connect. The D display icon will light up dimly for a few seconds on the control panel. To begin setting up the connection, touch the D display icon and proceed in accordance with the information given in the section entitled ~ "Home Connect". To exit initial set-up, touch any touch key. To switch the cooktop on, touch the ON l OFF touch key. An audible signal will sound. The symbols for the cooking zones and the functions available at this time will light up. ‹.‹ will light up next to the cooking zones. The cooktop is ready to use. To switch the cooktip off, touch and hold the ON l OFF touch key until all indicators go out. The residual heat indicator will remain lit until the cooking zones have cooled down sufficiently. Notes ▯ If the appliance has not been connected to your home network or the connection has been interrupted, Home Connect initial set-up will be activated whenever you switch on the cooktop. ▯ The cooktop switches off automatically if all the cooking zones have been switched off for a few seconds. ▯ The settings are stored for 4 seconds after the cooktop has been turned off. If you turn the cooktop back on during this time, the cooktop will continue using the stored settings. Setting a Cooking Zone Set the desired power level using the ò to ê symbols. Power level ò = lowest power level Power level ê = highest power level Every power level has an intermediate level, which is set using the @ or A symbol. Notes ▯ To protect the fragile parts of your appliance from overheating and electrical overloading, the cooktop may temporarily reduce the power automatically. ▯ In order to prevent the appliance from producing excess noise, the cooktop may temporarily reduce the power automatically. Selecting a cooking zone and power level The cooktop must be turned on. 1. Touch the ã symbol for the required cooking zone. The ‹.‹ display gets brighter. 2. Select the desired power level from the settings range. The power level is set. 11
![](/manual_guide/products/thermador-cit367xms-instructions-use-b6a2b9e/11.png)