Toshiba HD-D1 Firmware Upgrade - Page 17
Preparation of the remote control
View all Toshiba HD-D1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
1 Chapter Introduction Preparation of the remote control Set up the remote control to operate the player and your TV. Loading batteries Operating with the remote control 1 Open the cover. Point the remote control at the remote sensor and press the buttons. 2 Insert batteries. 7Use 4 batteries (AAA sizes). 7Make sure to match the + and - on the batteries to the marks inside the battery compartment. 3 Close the cover. Distance: About 7 m (23 ft) from the front of the remote sensor Angle : About 30° in each direction of the front of the remote sensor Notes Do not drop or give the remote control a shock. Do not leave the remote control near an extremely hot or humid place. Do not spill water or put anything wet on the remote control. Do not disassemble the remote control. Dispose of batteries in a designated disposal area. Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accordance with applicable laws and regulations. If the remote control does not operate correctly, or if the operating range becomes reduced, replace all batteries with new ones. When necessary to replace batteries in the remote control, always replace all batteries with new ones. Never mix battery types or use new and used batteries in combination. Be sure to use AAA size batteries. Always remove batteries from remote control if they are dead or if the remote control is not be used for an extended period of time. This will prevent battery acid from leaking into the battery compartment. Caution Never throw batteries into a fire. 16 Downloaded from www.Manualslib.com manuals search engine