Toshiba RD-XS35SU Owners Manual - Page 175

Introduction Precautions Notes on handling Never disconnect the power cord from a wall outlet while the recorder is not in standby mode, unless it is in an emergency. Doing so may cause malfunction. When shipping the recorder, the original shipping carton and packing materials come in handy. For maximum protection, repack the unit as it was originally packed at the factory. Do not use volatile liquids, such as insect spray, near the recorder. Do not leave rubber or plastic products in contact with the recorder for a long time. They will leave marks on the finish. The top and rear panels of the recorder may become warm after a long period of use. This is not a malfunction. Notes on cleaning Use a soft, dry cloth for cleaning. Do not use any type of solvent, such as thinner or benzine, as they may damage the surface of the recorder. Notes on antennas Image and sound quality depend very much on signal reception. Reception may be poor in weak signal areas. In this event, consult your dealer, or purchase a commercially available antenna booster. Refer to the booster's instruction manual for installation details. When not in use For usual absence Be sure to remove the disc from the recorder and turn off the power. Prolonged absence Unplug the recorder from a wall outlet. Notes on locating Place the recorder on a level surface. Do not use it on a shaky or unstable surface such as a wobbly table or inclined stand. The loaded disc may dislodge from its proper position and cause damage to the recorder. Before placing the recorder, make sure that the surface can stand the weight of the recorder. Never place the recorder in a high location to avoid damage to the product or person by an accidental fall of the recorder. When you place this recorder near a TV, radio, or VCR, the playback picture may become poor and the sound may be distorted depending on the condition and location of said equipment. In such an event, place the recorder as far away much as possible from the TV, radio, or VCR. To avoid damage to this product, never place or store the unit in direct sunlight; hot, humid areas; or areas subject to excessive dust, oily smoke, cigarette smoke or vibration. Notes on recording and editing When you record/edit important content, make trial operations beforehand to confirm the recorder can function properly. Toshiba does not compensate for content which was not recorded/edited because of some malfunction of this product or discs during operation, and is not liable for incidental damages (such as profit loss or interruption of business, etc.) produced in such conditions. When the power cord is disconnected or when a power failure occurs during any operation of this product, all contents recorded in this recorder may be erased. Depending on the channel or program, an excessive sound input level may cause noise or cut of recorded sound. Adjust the initial setting of the recording level when necessary. If a program you have set a timer recording includes copy restriction signals, it may not be recorded. When programming a recording, confirm that a program you want to record is not copy-restricted. Power outage After a power outage the clock display will flash. Set the clock to the correct time. 6 RD-XS35SU/SC_Inst_E_p02-18 6 06.2.13, 4:33 PM