Toshiba TLP-X2000 User Manual - Page 11

Preparing and using the remote control ■ Loading dry-cell batteries into the remote control q Remove the battery cover. w Insert the dry-cell batteries. Be sure to align the plus and minus ends of the batteries properly. ■ Operating the remote control Turn on the ON/OFF switch of the remote control. Point toward the projector's infrared remote sensor, and press a button on the remote control. • Operating the projector from the front Approx. 15° Approx. 5m Two batteries (LR03, SIZE AAA) are used. e Replace the battery cover. When operating the remote control from behind the projector, the light is reflected on the projecting surface and may travel a shorter distance to reach the projector depending on the shape and material of the projecting surface. Dry-cell batteries • Before using the batteries, be sure to observe the Safety Precautions described in previous pages. • Remove batteries from remote control when not using for extended periods. • If the remote control stops working, or if its range decreases, replace all the batteries with new ones. The remote control • When using more than 2 projectors, [Remote control] can make it possible to operate the remote control individually. p.43 • Turn off the ON/OFF switch of the remote control when not in use or to store in baggage. • The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting. • Do not drop or bang. • Do not leave in hot or humid locations. • Do not get wet or place on top of wet objects. • Do not take apart. • In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation. 20 Operating a computer using the remote control A computer can be operated using the projector's remote control. This function is available on any computer with the Windows® 98/98SE, Windows® Me, Windows® 2000, or Windows® XP OS, that is equipped with a USB port which can support USB1.1 (The mouse remote control receiver is also supported on OS 9 or OS X for the Macintosh). However, please note that Toshiba does not guarantee the operation of all computers. 1 Connecting a computer Connect the mouse remote control receiver (supplied) to a computer. To USB port Mouse remote control receiver The remote control may fail to operate if the mouse remote control receiver is exposed to bright sunlight or fluorescent lighting. In such a case, change position or direction of the mouse remote control receiver and retry. 2 Operating a computer Operate remote control's buttons towards the mouse remote control receiver. ● Moving the mouse pointer Press the mouse control button in the direction you wish the mouse pointer to move, then press. ● To left click Press the L-CLICK button. ● To right click Press the R-CLICK button. ● To drag and drop Holding down the L-CLICK button, move the mouse control button until the mouse pointer is over the desired location, then release the L-CLICK button. ● Using the computer's page up [↑] and down [↓] function Press the PAGE+ and PAGE- buttons to switch PowerPoint® slides. Remote Control Front Remote Control Rear Mouse control PAGE - R-CLICK L-CLICK PAGE + 21 Preparations