Tripp Lite PDU3VSR3G60 Owner's Manual for High Voltage 3-Phase PDU 932906 - Page 7

Installation Network Connection 5-2 Access PDU with Web Browser: After an IP address has been assigned to the PDU, attempt to access it with a Web browser that supports frames, forms and Java™. Open a Web browser on a computer connected to the LAN and enter the IP address assigned to the PDU. You should be prompted for a password A . The user name is admin and the default password is admin. After you enter the user name and password, the PowerAlert status page B A will appear in the browser window. For more information about configuration and operation of the PDU via the PowerAlert interface, refer to the SNMPWEBCARD User's Guide, included on the CD-ROM bundled with the PDU. Note for Network Management System Users Only: Two MIB files - Tripplite.mib and RFC1628.mib - must be loaded on each Network Management Station that will monitor the PDU via SNMP. The files are provided on the CD-ROM included in the B product package. Digital Load Meter 1 Phase Current/Flip Display Button: This button A can be pressed to show total current for each of the three outlet groups or Phases. Pressing this button once will display the total current for all of the outlets on Phase Bank 1, located nearest to the input cord. The LED for Phase 1 D will illuminate and the total current for Phase 1 outlets will display in amps in the LED Amps display C . Pressing this button A a second time will produce the same results for Phase Bank 2 and a third time for Phase Bank 3. The appropriate LEDs E or F will also illuminate and amps will appear in the display C . Pressing the button additional times will repeat the cycle. If you press and hold this button for 4 seconds, the numbers in the LED Amps display C will flip for mounting versatility. The unit can be mounted with the power cord facing the top or bottom while still being able to read the display. 7 F E D UP DOWN 201104185 93-2906.indb 7 B C A 5/18/2011 1:36:02 PM