Troy-Bilt Bronco CRT Service Manual - Page 17

Troy-Bilt Bronco CRT Manual

Get Troy-Bilt Bronco CRT PDF manuals and user guides View all Troy-Bilt Bronco CRT manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

7.6. Allow all of the gear oil to drain from the transmission case assembly. 7.7. Rotate the transmission 180° to the right until it is in the upright position. 7.8. Remove the front transmission cover gasket from the transmission using a scraper. See Figure 7.8. Wheel Worm Cover Gasket Troy-Bilt Small Frame Tillers 7.10. Remove the rear transmission cover gasket from the transmission using a scraper. See Figure 7.10. Cover Gasket Tine Worm Figure 7.8 7.9. Remove all four hex flange screws securing the rear transmission cover and gasket to the transmission housing assembly using a 1/2" socket. See Figure 7.9. Hex Screws Figure 7.10 7.11. Remove the remaining lower hex flange screw securing the rear bearing cap to the transmission housing assembly using a 1/2" socket. See Figure 7.11. Rear Bearing Cap Transmission Overlap Point Rear Transmission Cover Figure 7.9 Short Hex Flange Screw Figure 7.11 7.12. Break the rear bearing cap free from the transmission housing at any overlap position using a punch and hammer. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
Troy-Bilt Small Frame Tillers
13
7.6.
Allow all of the gear oil to drain from the trans-
mission case assembly.
7.7.
Rotate the transmission 180° to the right until it
is in the upright position.
7.8.
Remove the front transmission cover gasket
from the transmission using a scraper. See Fig-
ure 7.8.
7.9.
Remove all four hex flange screws securing the
rear transmission cover and gasket to the trans-
mission housing assembly using a 1/2” socket.
See Figure 7.9.
Figure 7.8
Cover Gasket
Wheel Worm
Figure 7.9
Rear Transmission Cover
Hex Screws
7.10.
Remove the rear transmission cover gasket from
the transmission using a scraper. See Figure
7.10.
7.11.
Remove the remaining lower hex flange screw
securing the rear bearing cap to the transmis-
sion housing assembly using a 1/2” socket. See
Figure 7.11.
7.12.
Break the rear bearing cap free from the trans-
mission housing at any overlap position using a
punch and hammer.
Figure 7.10
Cover Gasket
Tine Worm
Figure 7.11
Short Hex Flange Screw
Rear Bearing Cap
Transmission
Overlap Point