Troy-Bilt Bronco CRT Service Manual - Page 19

Troy-Bilt Small Frame Tillers 7.23. Remove the front tapered roller bearing and support washer, and inspect them for wear or damage. 7.24. Inspect the rear tapered roller bearing assembly for damage or wear. See Figure 7.24. Race Rear Tapered Roller Bearing 7.27. Remove the front tapered roller bearing race by lightly tapping on the perimeter with a small punch and a rubber mallet. NOTE: The race should be gently pushed into the center of the transmission housing for ease of removal. 7.28. Open the jaws of a vice and set a section of protective material into it. See Figure 7.28. Protective Material Drive Shaft Assembly Figure 7.24 NOTE: The rear tapered roller bearing and race can not be ordered separately, they are purchased with the drive shaft assembly. 7.25. Remove the front drive shaft oil seal using a flat blade screwdriver. See Figure 7.25. Race Transmission Assembly Vice Figure 7.28 7.29. Set the transmission assembly into the jaws of the vice and secure it. 7.30. Inspect the wheel shaft assembly for wear or damage inside the transmission case. See Figure 7.30. Internal Snap Ring Front Oil Seal Lubrication Cut A Way Bronze Bushing Spacer Wheel Shaft Worm Gear Figure 7.25 7.26. Remove the front internal snap ring using medium retaining ring pliers. Spacer Bronze Bushing Figure 7.30 15