Troy-Bilt Bronco CRT Service Manual - Page 37
SUPER BRONCO TILLER, ABOUT THIS UNIT FEATURES, Engine and Protective Bumper, REVERSE CLUTCH - super tiller
View all Troy-Bilt Bronco CRT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
SUPER BRONCO TILLER ABOUT THIS SECTION: NOTE: This section covers the Super Bronco Tiller, model 21A-634B063 with serial number 1B012G80125. This section has been technically written to follow along with the Troy-Bilt Factory School. In addition, the Super Bronco uses the same transmission as the Tuffy Tiller. Therefore, the following information only covers the subjects that are not covered in the Tuffy Tiller section of this book. If you need additional information, refer to the Tuffy Tiller section. UNIT FEATURES: • 6.5 Hp, 4 cycle engine. See the Image Below. Protective Bumper Troy-Bilt Small Frame Tillers 1. REVERSE CLUTCH CABLE REPLACEMENT: 1.1. Locate the reverse clutch cable at the upper handlebar. See Figure 1.1. Upper Handle Bar Reverse Clutch Cable Figure 1.1 1.2. Remove the front jam nut securing the reverse clutch cable to the upper handlebar bracket using a 7/8" wrench. See Figure 1.2. Upper Handle Bracket 13" Ag. Tires Engine and Protective Bumper • Protective bumper • Power forward and reverse • 16" tilling width • 10" tine diameter • Adjustable tilling depth up to 6" • 13" Agricultural tires Jam Nut Figure 1.2 1.3. Remove the reverse clutch cable from the upper handlebar bracket. 33