Troy-Bilt Bronco CRT Service Manual - Page 36

Troy-Bilt Small Frame Tillers 8.117. Fill the transmission assembly with gear oil until it is half way up the worm gears. See Figure 8.117. Gear Oil Worm Gear 8.120. Secure the transmission covers to the transmission with the hex flange screws removed earlier using a 1/2" socket. 8.121. Perform the Transmission Removal section in the reverse order to complete the tiller assembly. 8.122. Perform the Forward Clutch Cable Adjustment section prior to operating the tiller. 9. FORWARD IDLER LEVER PIVOT: 9.1. The following picture shows the orientation of the forward idler pivot hardware. See Figure 9.1. Hex Screw Idler Pulley Figure 8.117 NOTE: When refilling an empty transmission, use only GL-4 gear oil having a viscosity of SAE 85W-140. Uses approximately 16 fluid ounces. 8.118. Place new front and rear housing cover gaskets in position. See Figure 8.118. Rear Gasket Front Gasket Forward Idler Lever Shoulder Washer Hex Screw Flat Washer Figure 9.1 Lock Washer Figure 8.118 NOTE: Make certain the thin portion of the gasket is facing out, and the thick portion of the gasket is facing in. 8.119. Set the front and rear transmission covers in position. NOTE: The front transmission cover's oil fill plug faces rearward. 32