Troy-Bilt TB30 Operation Manual - Page 11
Attaching The Seat
View all Troy-Bilt TB30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
5. Tighten the shoulder bolt and lock nut using a 9/16" wrench and 7/16"wrench or socket. 6. Remove the pedestal cap mount hex screw factory installed and located on the tractor's steering console. Retain the screw for later instructions. 7. Slide the Pedestal cap down onto the tractor (1) and slighty rotate to the right to clip into place. Secure the pedestal with the hex screw (2) previously removed. See Figure 3-3. 2 1 Figure 3-5 3. Align the seat bracket in place over the holes from where the self-tapping bolts were removed, as shown in Figure 3-6. 4. Using a 1/4-inch drive ratchet with a 3/8" socket, secure the seat bracket with the self-tapping bolts removed in step 2. See Figure 3-6. Figure 3-3 Attaching The Seat If the seat for your tractor was not attached at the factory, follow the applicable instructions below to attach it. 1. Remove the shoulder bolts and lock nuts from the seat mounting bracket included in your hardware pack. See Figure 3-4. Figure 3-6 Figure 3-4 2. Remove the two self-tapping bolts factory installed on the tractor. See Figure 3-5. CAUTION: Do not use any type of power tool (e.g. impact gun or electric drill with nut driver attached) when tightening the self-tapping bolts to attach the seat bracket. 5. Position the seat assembly over the seat mounting bracket, aligning the holes provided. Section 3 - Assembly & Set-Up 11