Vaddio ConferenceSHOT AV ConferenceSHOT AV Integrator s Complete Guide - Page 42
Testing Triggers, To test a trigger
View all Vaddio ConferenceSHOT AV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Integrator's Complete Guide to the ConferenceSHOT AV Enterprise-Class Conferencing System Testing Triggers CONTROL DEVICES PAGE The Trigger Testing section is available from both tabs of the Control Devices page. Trigger indicators illuminate to show that the trigger is on. To test a trigger: 1. Set Test Mode on. 2. Select the trigger to turn on. 3. Select the trigger again to turn it off. Note Turn off Test Mode when you are finished testing; otherwise, the triggers are not available to the control device. Diagnostic: If you send a trigger command via Telnet and the command returns an error message, check to see whether Test Mode is on. 38
Testing Triggers
C
ONTROL
D
EVICES PAGE
The Trigger Testing section is available from both tabs of the Control Devices page. Trigger indicators
illuminate to show that the trigger is on.
To test a trigger:
1.
Set Test Mode on.
2.
Select the trigger to turn on.
3.
Select the trigger again to turn it off.
Note
Turn off Test Mode when you are finished testing; otherwise, the triggers are not available to the control
device. Diagnostic: If you send a
trigger
command via Telnet and the command returns an error
message, check to see whether Test Mode is on.
38
Integrator's Complete Guide to the ConferenceSHOT AV Enterprise-Class Conferencing System