ViewSonic PJ558D PJ558D User Guide - Page 34

of the lamp assembly. - projector lamp replacement

Get ViewSonic PJ558D PDF manuals and user guides
UPC - 766907240115
View all ViewSonic PJ558D manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

1. Turn off the projector and unplug the AC power cord. 2. Place a protective sheet (cloth) beneath the projector. Turn the projector over so you can access the lamp cover. 3. Remove the access panel screws and open the panel. 4. Remove the screws on the bottom of the lamp assembly. 5. Grasp the lamp handle and pull the lamp assembly directly out of the projector. 6. Replace with the new lamp. 7. Place back the screws on the bottom of lamp assembly. 8. Place the panel and screw back the screws on the lamp cover. English Dispose of the used lamp according to local regulations. Ensure that screws are tightened properly. Screws not tightened fully may result in injury or accidents. Since the lamp is made of glass, do not drop the unit and do not scratch the glass. Do not reuse the old lamp. This could cause the lamp to explode. Be sure to turn off the projector and unplug the AC power cord before replacing the lamp. Do not use the projector with the lamp cover removed. 29 ViewSonic PJ558D

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
Engl±sh
ViewSonic
PJ558D
29
1.
Turn off the projector and unplug
the AC power cord.
2.
Place a protect±ve sheet (cloth)
beneath the projector. Turn the
projector over so you can access
the lamp cover.
3.
Remove the access panel screws
and open the panel.
4.
Remove the screws on the bottom
of the lamp assembly.
5.
Grasp the lamp handle and pull the
lamp assembly d±rectly out of the
projector.
6.
Replace w±th the new lamp.
7.
Place back the screws on the
bottom of lamp assembly.
8.
Place the panel and screw back the
screws on the lamp cover.
D±spose of the used lamp accord±ng to local regulat±ons.
Ensure that screws are t±ghtened properly. Screws not t±ghtened fully may
result ±n ±njury or acc±dents.
S±nce the lamp ±s made of glass, do not drop the un±t and do not scratch the
glass.
Do not reuse the old lamp. Th±s could cause the lamp to explode.
Be sure to turn off the projector and unplug the AC power cord before replac±ng
the lamp.
Do not use the projector w±th the lamp cover removed.