ViewSonic PRO10100 - 1024 x 768 Resolution 6 000 ANSI Lumens 1.26-1.28 Throw Rat - Page 62

Projector Problems The projector stops responding to all controls `` If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before reconnecting power. `` Check that "Keypad Lock" is not activated by trying to control the projector with the remote control. Lamp burns out or makes a popping sound `` When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in the "Replacing the Lamp" section. If the remote control does not work `` Check if the operating angle of the remote control is within ±30° both horizontally and vertically on one of the IR receivers on the projector. `` Make sure there is no obstruction between the remote control and the projector. Move to within 12 m (±0°) of the projector. `` Make sure the batteries are inserted correctly. `` Replace batteries if they are exhausted. `` Ensure that you have set your remote to the correct IR code setting. When making a direct connection from your computer to the projector `` If you have network connection problem from your computer to the projector, please refer to the computer setting as below or contact with web administrator. Step 1: Find an IP Address (192.168.0.100) from LAN function of projector. Step 2: Select "Apply" and push the "Enter" button. Once the setting is saved, exit the OSD by pushing "Menu" button. Step 3: To open Network Connections, click Start, click Control Panel, click Network and Internet Connections, and then click Network Connections. Click the connection you want to configure, and then, under Network Tasks connection. , click Change settings of this 61