ViewSonic PRO10100 - 1024 x 768 Resolution 6 000 ANSI Lumens 1.26-1.28 Throw Rat - Page 67
Lamp Replacing Procedure
View all ViewSonic PRO10100 - 1024 x 768 Resolution 6 000 ANSI Lumens 1.26-1.28 Throw Ratio manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
1 2 3 4 Lamp Replacing Procedure: 1. Switch off the power to the projector by pressing the " " button. 2. Allow the projector to cool down for at least 30 minutes. 3. Disconnect the power cord. 4. Unscrew the two screws on the lamp door. 1 5. Open and pull up the lamp door. 2 6. Unscrew the three screws on the lamp housing. 3 7. Pull out the lamp module slowly and carefully. 4 To replace the lamp module, reverse the previous steps. 8. Turn on the projector and use "Lamp Reset" after the lamp module is replaced. Lamp Reset: (i) Press "Menu" (ii) Select "OPTIONS" (iii) Select "Lamp Settings" (iv) Select "Lamp Reset" (v) Select "Yes". 66
66
Lamp Replacing Procedure:
1.
Switch off the power to the projector by pressing the “
” button.
2.
Allow the projector to cool down for at least 30 minutes.
3.
Disconnect the power cord.
4.
Unscrew the two screws on the lamp door.
1
5.
Open and pull up the lamp door.
2
6.
Unscrew the three screws on the lamp housing.
3
7.
Pull out the lamp module slowly and carefully.
4
To replace the lamp module, reverse the previous steps.
8.
Turn on the projector and use “Lamp Reset” after the lamp module
is replaced.
Lamp Reset: (i) Press “Menu”
(ii) Select “OPTIONS”
(iii) Select
“Lamp Settings”
(iv) Select “Lamp Reset”
(v) Select “Yes”.
1
2
3
4