Viking RDSCE2305BSS Use and Care Manual - Page 23

Product Care Replacing ODvAeNnGLEigRhts WARNING ELECTRICAL SHOCK HAZARD Disconnect the electric power at the main fuse or circuit breaker before replacing bulb. CAUTION To avoid risk of personal injury, DO NOT touch bulb with bare hands. Clean off any signs of oil from the bulb and handle with a soft cloth. 1. Unsnap glass light cover using a screwdriver in the access groove. glass light cover 2. Firmly grasp light bulb and access groove pull out. 3. Replace with halogen bulb using volt and wattage requirements listed on glass light cover. bulb 4. FOR YOUR Replace the light cover by SAFETY snapping glass cover onto metal box. 5. Reconnect power at the main fuse or circuit breaker. 44 Door Removal WARNING TO PREVENT PERSONAL INJURY Before removing the doors, make sure the pins are properly installed in the hinges. Failure to do so can result in personal injury to hands and/or fingers. 2 1 Open door completely. Place pin in pin hole. 3 Remove hinge trim screws and hinge trim. 4 Close until pins stop door. Lift door up and out. Note: Professional oven shown. 45 Product Care