Viper 5601 Owner Manual - Page 18

Using the system ➤ Arming the system To arm the system, press the button on the remote control. The siren in the vehicle will "chirp" once and the parking lights will flash once. If the power door locks have been connected, the doors will lock. The system will automatically check for errors when it arms. A U X If errors are found when arming: If an alarm trigger zone - such as a door, the trunk, the hood, or a sensor, was active at the time of arming, the system will "bypass", or ignore, this trigger zone. This allows the system to continue to protect your vehicle using the remaining trigger zones. You are notified of this active zone immediately after arming the system. The siren in the vehicle will "chirp" again and the parking lights will flash again. The Status LED indicator in the vehicle will blink in a pattern to indicate the active zone number error which was found (See Table of Zones on page 34). Arming withouAUtX the chirp (Silent Arm): Press the button at the bottom of the remote once, and then press the button. The system will arm without the confirmation chirp. The parking lights will flash once. ➤ While the system is armed A U X • Fail-Safe Starter Kill The starter is disabled by the system's Fail-Safe starter kill (if installed). 18 © 2008 Directed Electronics. All rights reserved.