Viper 5601 Owner Manual - Page 31

Valet take-over

Get Viper 5601 PDF manuals and user guides View all Viper 5601 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

➤ Valet take-over The Valet take-over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the climate controls on. To perform Valet take-over: 1. Before turning off the engine, press and release onAUX the trans- mitter. Then wait a few seconds. 2. Turn the ignition key to the OFF position (The engine will stay running). 3. The engine will run until the pre-programmed time elapses or a shut-down input is received. Note: To enable Valet take-over with a manual transmission, open the door and enter into manual transmission mode, as described above. The parking lights flash five times when entering Valet take-over. Once you exit the vehicle you can lock the system and the car will remain running. If the vehicle shuts down when locking, then the unit did not enter valet take-over mode. © 2008 Directed Electronics. All rights reserved. 31

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
31
© 2008 Directed Electronics. All rights reserved.
➤
Valet take-over
The Valet take-over feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful for
occasions when you wish to exit and lock the vehicle for short periods
of time, but would like to leave the motor running and the climate
controls on.
To perform Valet take-over:
Before turning off the engine, press and release
1.
on the trans-
mitter. Then wait a few seconds.
Turn the ignition key to the OFF position (The engine will stay
2.
running).
The engine will run until the pre-programmed time elapses or a
3.
shut-down input is received.
Note:
To enable Valet take-over with a manual transmission, open the
door
and enter into manual transmission mode, as described above.
The parking lights flash five times when entering Valet take-over. Once
you exit the vehicle you can lock the system and the car will remain
running. If the vehicle shuts down when locking, then the unit did not
enter valet take-over mode.