Viper 7900 Owner Manual - Page 30
disarming without a remote control
View all Viper 7900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
➜ disarming without a remote control If your remote control should be lost, damaged or fail to operate the system, the ignition and Valet Switch can be used to disarm the alarm. You must know where the Valet Switch is located and the correct number of presses required for the alarm to disarm. Have your installer familiarize you with this procedure. The siren will be sounding while you are disarming which can be quite distracting. 1.Open the driver's door and enter the vehicle. 2.Turn the ignition to the on posi- tion DRW-35 3.Within 5 seconds press and release the Valet Switch the correct number of times 4.3 seconds later the alarm will disarm and the siren will turn off. If the alarm fails to disarm, return to step 2 above. note: 1 press is the default number of valet switch presses required to disarm the alarm. Your installer can program 2-5 presses if desired. NUMBER OF PRESSES VALET SWITCH LOCATION 26 © 2006 directed electronics-all rights reserved