Viper 7900 Owner Manual - Page 36
Disarm the alarm and unlock the doors
View all Viper 7900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
b. The lights will flash as confirmation the remote start command was received. c. The system will send a remote start response to the remote control. d. A few seconds later the engine will start. For diesel vehicles there may be a delay for the glow plugs to warm. e. Once started, the engine will run for the programmed run time and the lights will continue to flash or turn on. "remote" The remote control Notification will be two beeps ascending in tone followed by the remote start animation. to drive the vehicle a. Disarm the alarm and unlock the doors b. Enter the vehicle but DO NOT step on the brake pedal. c. Insert the key and turn the ignition to the run or on position d. Step on the brake pedal, the remote start will shut down and the engine will continue to run. You are ready to drive. to turn the engine off While the remote start is active, the system will turn off if any of the following occur: a. Press and release the button of the remote control two times quickly. b. Step on the brake c. Open the hood 32 © 2006 directed electronics-all rights reserved