Viper 7900 Owner Manual - Page 48

power saver mode

Get Viper 7900 PDF manuals and user guides View all Viper 7900 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 48 highlights

and the battery is dis­con­nect­ed for any reason, such as servicing the car, when the battery is re­con­nect­ed the unit will still be in Valet Mode. This applies to all states of the system including arm, disarm, and Valet Mode. power saver mode Your system will automatically enter Power Saver Mode while armed or in Valet Mode, after a period of time in which no operation has been performed. This lowers the current draw on the vehicle's battery. Power Saver Mode takes over under the following conditions: ➤ Power Saver when the system is armed: After the system has been armed for 24 hours the LED will flash at half its normal rate, decreasing the system's current draw. ➤ Power Saver in Valet Mode: When the system enters Valet Mode the LED illuminates steadily. If the vehicle is not used (ignition is not turned on) for a one hour period while the system is in Valet Mode, the LED will shut off. If the system remains in Valet Mode, the LED will come back on the next time the ignition is turned on and then back off. 44 © 2006 directed electronics-all rights reserved

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
µµ
© 2006 directed electronics—all rights reserved
and the battery is disconnected for any reason, such as servicing the
car, when the battery is reconnected the unit will still be in Valet
Mode. This applies to all states of the system including arm, disarm,
and Valet Mode.
power saver mode
Your system will automatically enter Power Saver Mode while armed
or in Valet Mode, after a period of time in which no operation has
been performed. This lowers the current draw on the vehicle's battery.
Power Saver Mode takes over under the following conditions:
➤
Power Saver when the system is armed: After the system
has been armed for 24 hours the LED will flash at half its
normal rate, decreasing the system's current draw.
➤
Power Saver in Valet Mode: When the system enters Valet
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a one hour period while the
system is in Valet Mode, the LED will shut off. If the system
remains in Valet Mode, the LED will come back on the next
time the ignition is turned on and then back off.