Vtech CS6649-2 User Manual - Page 15

NO BATTERY. Battery indicators Battery status Action The screen is blank, or displays Put in charger and flashes. The battery has no or very little charge. The handset cannot be used. Charge without interruption (about 30 minutes). The screen displays Low battery and flashes. The battery has enough charge to be used for a short time. Charge without interruption (about 30 minutes). The screen displays HANDSET X. The battery is charged. To keep the battery charged, place it in the handset charger when not in use. When the battery is fully charged, you can expect the following performance: Operation While in handset use (talking*) While in speakerphone mode (talking*) While not in use (standby**) Operating time Up to 7 hours Up to 3.5 hours Up to 5 days * Operating times vary depending on your actual use and the age of the battery. ** Handset is not charging or in use. Before use After you install your telephone or power returns following a power outage, the handset will prompt you to set the date and time. Set date and time NOTE Make sure you set the date and time including the year correctly; otherwise the answering system does not announce the correct day of the week for your recorded messages time stamp. 1. Use the dialing keys (0-9) to enter the month (MM), date (DD) and year (YY). Then press SELECT. 2. Use the dialing keys (0-9) to enter the hour (HH) and minute (MM). Then press or to choose AM or PM. 3. Press SELECT to save. Check for dial tone Press . If you hear a dial tone, the installation is successful. If you do not hear a dial tone: • Make sure the installation procedures described above are properly done. • It may be a wiring problem. If you have changed your telephone service to digital service from a cable company or a VoIP service provider, the telephone line may need to be rewired to allow all existing telephone jacks to work. Contact your cable/VoIP service provider for more information. 8