Vtech Kidizoom Smartwatch DX2 Blue User Manual - Page 5

WEARING THE SMARTWATCH People with very sensitive skin may notice some irritation after wearing the Kidizoom® Smartwatch DX2 for extended periods of time. The skin may become irritated when moisture, sweat, soap, or other irritants get trapped under the watch band and are left in contact with the skin. To prevent this, we suggest children remove the watch before going to bed for the night, take the watch off if it's feeling uncomfortable, and keep their wrist and the band clean and dry. In addition, wearing the watch too tightly may also cause irritation. Make sure the fit is good - tight enough so the watch stays in place but not so tight that it's uncomfortable. If you notice any redness, swelling, or other irritation, you may want to consult a doctor before wearing the watch again. GETTING STARTED Master Power Switch When you use Kidizoom® Smartwatch DX2 for the first time, you will need to slide the Master Power Switch (located on the underside of the watch) to the ON position . You may need a small tool such as a paper clip to move the switch to the on position. Then, fully charge the watch before first use. A full charge will take about 3 hours. When the Master Power Switch is set to the OFF position, the unit will not function and the battery will not charge. Only move the switch to the OFF position when the watch will not be used for an extended period of time. Note: It is not necessary to switch off the watch in daily use. Once the master power switch is off, the watch will stop functioning and after it is turned on again, the time and date has to be reset. BATTERY RECHARGING Note: Adult operation required. To charge Kidizoom® Smartwatch DX2, the watch needs to be connected to a computer with the included Micro-USB Cable. To do so correctly, please follow these steps: • Make sure that the Master Power Switch is set to the ON position before charging. • Pull up the rubber cover of the Micro-USB Port on the side of the watch. 5