Weber Summit Platinum D6 LP Owner Manual - Page 26

26 OPERATING INSTRUCTIONS LIGHTING THE ROTISSERIE BURNER 1 ƽATTENTION: READ BEFORE LIGHTING ROTISSERIE BURNER After a period of non-use, before lighting the Rotisserie Burner, a few seconds must pass for the gas supply line to fill. When holding the ignition button you will see a flash of flames moving from right to left across the Rotisserie Burner surface, the Rotisserie Burner is not lit until the entire ceramic surface is aflame. At this point, start a count of 20 seconds before releasing the Rotisserie Burner control knob. The Rotisserie Burner surface will glow red once the burner is fully ignited. ƽCAUTION: The Rotisserie Burner flame may be difficult to see on a bright sunny day. ƽWARNING: Check hose before each use of grill for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the grill. Replace using only a Weber® authorized replacement hose. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. 1) Open the lid. 2) Remove the warming rack and the cooking grates from the cookbox. ƽDANGER: Failure to open the lid while igniting the grill, or not waiting 5 minutes to allow the gas to clear if the grill does not light, may result in an explosive flare-up which can cause serious bodily injury or death. 8 3 6 4 3 5 ,7 *The grill illustrated may have slight differences than the model purchased. SUMMIT® D