Weber Summit Platinum D6 LP Owner Manual - Page 32
Rotisserie Troubleshooting
View all Weber Summit Platinum D6 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
32 ROTISSERIE TROUBLESHOOTING PROBLEM Burner does not light. CHECK Did you hold the burner control knob down and hold down for 20 seconds until after burner ignited? CURE Try to relight burner by holding burner control knob down and continue holding down until 20 seconds after burner has ignited. Did you wait to see the entire ceramic surface become alight before counting 20 seconds? When relighting burner by holding burner control knob down, wait to see the entire ceramic surface become alight before counting 20 seconds? Is the igniter sparking? Replace battery in igniter button module. Reseat burner ring. Burners do not light. -or- Burner hsa asmall flickering flame The excess flow safety device, which is part of the barbecue to cylinder connection, may have activated. To reset the excess flow safety device turn all burner control knobs and the cylinder valve OFF. Disconnect the regulator from the cylinder. Turn burner control knobs to HIGH. Wait at least 1 minute. Turn burner control knobs OFF. Reconnect the regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting Instructions". If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.