Weber Summit Platinum D6 LP Owner Manual - Page 34

34 MAINTENANCE MAIN BURNER FLAME PATTERN The Weber® gas barbecue burners have been factory set for the correct air and gas mixture. The correct flame pattern is shown. 1) Burner tube 2) Tips occasionally flicker yellow (1) 3) Light blue 4) Dark blue (2) If the flames do not appear to be uniform throughout the burner tube, follow the burner cleaning procedures. (3) (4) MAIN BURNER CLEANING PROCEDURE Turn off the gas supply. Remove the manifold (See "Replace Main Burners"). Look inside each burner with a flashlight. Clean the inside of the burners with a wire (a straightened-out coat hanger will work). Check and clean the air shutter opening at the ends of the burners. Check and clean the valve orifices at the base of the valves. Use a Steel bristle brush to clean outside of burners. This is to make sure all the burner ports are fully open. ƽ CAUTION: Do not enlarge the burner ports when cleaning. REPLACE MAIN BURNERS 1. Your Summit® gas grill must be OFF and cool. 2. Turn gas OFF at source. 3. Disconnect regulator. 4. Remove cooking grates. 5. Remove Smoker box. 6. Remove Flavorizer® bars. 7. To remove control panel refer to "Remove the control panel" under "Check for Gas Leaks." 8. Disconnect all ignition wires from the Ignition Module. Gold A4 -+ -+ ab a = Yellow Tab with Black Wire b = White Tab with Black Wire Gold B4 -+ -+ ac bd a = Yellow Tab with Black Wire b = White Tab with Black Wire c = Solid White Wire d = Grounding Wire Gold D4 -+ -+ a c ef bd a = Blue Tab with Black Wire b = Yellow Tab with Black Wire c = White Tab with Black Wire d = Solid White Wire e = Solid Blue Wire f = Grounding Wire