Weider 14933 Instruction Manual - Page 13

Attach two Half Guards 35 and a Cable Trap

Page 13 highlights

15. See the CABLE DIAGRAM. Identify the Long Cable (52). 15 Orient the Long Cable (52) so that the end with the stop is in the location shown. Route the Long Cable through the Guide (4). Insert a Pulley (32) over the Long Cable (52) inside the Guide (4). Attach the Pulley with an M10 x 45mm Bolt (39) and an M10 Locknut (47). 47 32 Stop 52 4 39 16. Insert a Pulley (32) over the Long Cable (52) inside the Guide (4). Attach the Pulley with an 16 M10 x 45mm Bolt (39) and an M10 Locknut (47). 17. Route the Long Cable (52) over a Pulley (32). 17 Attach two Half Guards (35) and a Cable Trap (33) to the Pulley Plates (34) and the Pulley (32) with an M10 x 50mm Bolt (46) and an M10 Locknut (47). Make sure that the Cable Trap (33) is oriented to hold the Long Cable (52) in the groove of the Pulley (32). 32 52 47 4 39 47 34 32 35 35 46 33 52 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

13
15.
See the CABLE DIAGRAM. Identify the Long
Cable (52).
Orient the Long Cable (52) so that the end with
the stop is in the location shown. Route the Long
Cable through the Guide (4).
Insert a Pulley (32) over the Long Cable (52)
inside the Guide (4). Attach the Pulley with an
M10 x 45mm Bolt (39) and an M10 Locknut (47).
15
Stop
4
4
39
39
47
47
32
52
32
16. Insert a Pulley (32) over the Long Cable (52)
inside the Guide (4). Attach the Pulley with an
M10 x 45mm Bolt (39) and an M10 Locknut (47).
16
17
52
17. Route the Long Cable (52) over a Pulley (32).
Attach two Half Guards (35) and a Cable Trap
(33) to the Pulley Plates (34) and the Pulley
(32) with an M10 x 50mm Bolt (46) and an M10
Locknut (47).
Make sure that the Cable Trap (33) is oriented
to hold the Long Cable (52) in the groove of
the Pulley (32).
32
34
33
35
35
52
46
47