Weider 150 English Manual - Page 8

5. Slide the Weight Carriage (15) onto the Upper Lat Tower (41). The Weight Carriage must be turned as shown. Press a 2 1/2" Square Bushing (16) into the Carriage Stop (52). Slide the Square Bushing and the Carriage Stop onto the Upper Lat Tower (41). Align the holes in the Carriage Stop with the indicated hole in the Upper Lat Tower. Insert an M8 x 54mm Bolt (6) through the Carriage Stop and the Upper Lat Tower. Tighten an M8 Nylon Locknut (1) onto the Bolt. Slide the Upper Lat Tower (41) onto the Lower Lat Tower (23). The Upper Lat Tower must be turned as shown. Insert an M8 x 54mm Bolt (6) through the Connector Plate (19), the Upper Lat Tower, and the Cross Brace (43). Tighten an M8 Nylon Locknut (1) onto the Bolt. Tighten all the Nylon Locknuts used in steps 1, 2, 4, and 5 now. 5 15 16 152 1 4 6. Attach the indicated end of the Cable (10) to the M8 Eyebolt (13). Feed the Cable up through the indicated hole in the Upper Lat Tower (41). Wrap the Cable (10) around a Pulley (9). Attach the Pulley inside the Upper Lat Tower (41) with an M10 x 54mm Bolt (8), two M10 Washers (7), two 1/2" x 3/8" Spacers (11), and an M10 Nylon Locknut (2). 6 11 9 8 41 41 Align these Holes 6 19 23 2 7 The plastic sleeve should be on this end of the Cable -10 13