Weider 8970 Uk Manual - Page 10

15. Wrap the Butterfly Cable (46) under a 90mm 15 Pulley (38). Attach the Pulley and a pair of Pulley Covers (44) to the Double "U"-bracket (37) with an M10 x 53mm Bolt (61) and an M10 Nylon Locknut (71). Make sure the small tabs on the Pulley Covers are on top. 16. Wrap the Butterfly Cable (46) over a "V"-pulley 16 (39). Attach the "V"-pulley and a Long Cable Trap (40) to the bracket on the Front Upright (6) with an M10 x 57mm Bolt (69) and an M10 Nylon Locknut (71). Make sure the Cable Trap is turned to hold the Cable in the groove of the Pulley. 46 Small Tabs 44 38 44 61 71 37 69 46 40 39 6 71 17. Attach the Butterfly Cable (46) to the indicated 17 Pivot Bracket (48) with an M8 x 27mm Shoulder Bolt (63) and an M8 Nylon Locknut (70). 63 46 48 18. Locate the High Cable (45). Route the bolt end of the Cable up through the Top Frame (8) and over a 90mm Pulley (38). Attach the Pulley inside the Top Frame with an M10 x 68mm Bolt (59), two M10 Washers (26), two 13mm Spacers (34), and an M10 Nylon Locknut (71). 19. Wrap the High Cable (45) over a 90mm Pulley (38). Attach the Pulley inside the Top Frame (8) with an M10 x 68mm Bolt (59), two M10 Washers (26), two 13mm Spacers (34), and an M10 Nylon Locknut (71). 70 18 71 34 8 38 26 34 26 59 45 19 34 26 71 45 8 38 26 34 59 10