Weider 8970 Uk Manual - Page 13
Seat Assembly
View all Weider 8970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
30. Wrap the Low Cable (47) over a 90mm Pulley 30 (38). Attach the Pulley and a pair of Pulley Covers (44) to the Large "U"-bracket (82) with an M10 x 53mm Bolt (61) and an M10 Nylon Locknut (71). Make sure the small tabs on the Pulley Covers are on the bottom. 82 71 61 44 Small Tab 38 47 44 31. Wrap the Low Cable (47) under a 90mm Pulley (38). Attach the Pulley and a pair of Pulley Covers (44) inside the Front Upright (6) with an M10 x 68mm Bolt (59), two M10 Washers (26), two 8mm Spacer (51), and an M10 Nylon Locknut (71). Make sure the large tabs on the Pulley Covers are oriented as shown. 31 71 26 Large Tab 51 44 38 47 51 6 44 26 59 32. Route the Low Cable (47) through the Seat Upright (73) and under a 90mm Pulley (38). Attach the Pulley and a pair of Pulley Covers (44) inside the Seat Upright with an M10 x 68mm Bolt (59), two M10 Washers (26), two 8mm Spacer (51), and an M10 Nylon Locknut (71). Make sure the small tabs on the Pulley Covers are on the bottom. See the inset drawing. Attach the end of the Low Cable (47) to the Leg Lever (4) with an M8 x 27mm Shoulder Bolt (63) and an M8 Nylon Locknut (70). SEAT ASSEMBLY 33. Orient the Seat (16) as shown. Attach the Seat to the Seat Frame (5) with an M6 x 65mm Screw (65), an M6 Washer (35), and two M6 x 15mm Screws (66). 32 71 26 51 44 38 4 47 70 63 33 Wide End 44 47 Small Tab 16 73 51 26 59 5 35 66 65 13