Weider Pro 3750 User Manual - Page 15

31. Route the Press Cable (88) over a 90mm Pulley 31 (82). Attach the Pulley and a Cable Trap (80) to the lower hole in the Pulley Plates (31) with an M10 x 48mm Bolt (50) and the M10 Nylon Locknut (42). The Cable must be routed from the direction shown. Make sure that the Cable Trap is positioned to hold the Cable in place. 31 31 42 50 80 82 88 32. Route the Press Cable (88) under a 90mm Pulley 32 (82). Attach the Pulley and a Cable Trap (80) to the Leg Press Upright (4) with an M10 x 92mm Bolt (76), an M10 Washer (38) and an M10 Nylon Locknut (42). Make sure that the Cable Trap is turned to hold the Cable in place. 33. Route the Press Cable (88) over a 90mm Pulley (82). Attach the Pulley and a Cable Trap (80) to the indicated hole in the Press Frame (12) with an M10 x 82mm Bolt (66), an M10 Washer (38), and the M10 Nylon Locknut (42). 88 82 76 80 33 4 38 42 42 34. Wrap the Press Cable (88) around a "V"-pulley (81). Attach the "V"-pulley to the upper bracket 34 on the Leg Press Upright (4) with an M10 x 57mm Bolt (91) and an M10 Nylon Locknut (42). 66 38 88 82 80 12 91 81 4 88 42 15