Weider Pro 3750 User Manual - Page 7
M8 x 63mm Carriage Bolts 49 in the Press Base - fire
View all Weider Pro 3750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
4. Slide the Front Seat Frame (8) onto the indicated M8 x 63mm Carriage Bolts (49) in the Press Base (13). Hand tighten two M8 Nylon Locknuts (40) onto the Carriage Bolts. Do not tighten the Locknuts yet. Attach the other end of the Front Seat Frame (8) to the Leg Press Upright (4) with two M8 x 67mm Bolts (55), two M8 Washers (20), and two M8 Nylon Locknuts (40). Do not tighten the Locknuts yet. 4 55 20 40 8 4 40 13 49 5. Insert two Weight Guides (23) into one of the 5 brackets on the Weight Base (14). Make sure the Weight Guides are oriented with the tall holes near the top (see the inset drawing). Attach the lower ends of the Weight Guides to the Base with 23 an M8 x 152mm Bolt (67), two 13mm x 19mm Tall Spacers (69), and an M8 Nylon Locknut (40). Do Hole 23 not overtighten the Locknut. Attach the other Weight Guides (23) in the 40 same manner. 6. Slide a Weight Bumper (27) onto each of the Weight Guides (23). Slide eight Weights (90) onto each set of Weight Guides (23). Make sure that the pin grooves are on the indicated side of each stack of Weights. 14 69 6 90 Pin Grooves 67 90 Pin Grooves 27 27 7. Press a Weight Tube Bumper (26) into each Weight Tube (25). Insert a Weight Tube (25) into each stack of Weights (90). Make sure that the pins on the Weight Tubes are in the pin grooves in the upper Weights. 23 23 7 25 26 90 90 Groove 7